Boss had to be turned then welded to tube.Tightly sleeves over the landrover UJ and welded.I also drilled a hole in bottom of UJ to let the water out ,any trapped water in the winter can do some serious damage when frozen.
After Welding
Studs welded to take up slack on rotating pole.Inside the tube is 68mm,pipe will be 65mm ,so a little play .
Bottom is drilled to put a drive dowel through the pole.Bit of cold galv and i recon the top is done .
What's left to do know is mount the rotary encoder on the base of output shaft ...and i'm good to go !!!
No comments:
Post a Comment