My trials and tribulations

Hi all ,this blog is going to show some of the tricks in my life ,Enjoy !

Friday, 8 August 2014

Back to the winch (raise and lower)

Back to the winch .Having fitted the triplex chain ,it really needs a guard on it !!




Off cut of 3mm from the workshop steel archive !! cut and shaped 


Welded a band around the 2 half's then cut through middle ,makes a clamshell guard


This will keep the weather off the chain ,also keep the kids from getting there fingers in it ,having said that the winch is in the air abt 6ft/1.8m

A lick of paint is all i need to finish this now,unfortunately im struggling with a bad back and retired from workshop duty for a bit  

Saturday, 19 July 2014

Rotator install



A rush to beat the rain with the install ...but its up there ,however the rain beat us to the mark so still have the cable to install to the house :-(

What a thunder storm ,constant lightning ...eyes fixed on top of mast !!! 
Fitted a new stub mast too at 6m ,however im not happy with it it's 52 mm 6mm wall aluminum i recon 65mm will stop the sway a little .


Friday, 18 July 2014

Rotator for under £150


At last its all done and ready to install 




 Cable from the bottom is from the rotary encoder


Sunday, 6 July 2014

Fitting rotary encoder

Fitting of rotary encoder ,all that had to be done here is turn an adapter down to fasten and centralise the encoder

 Its in ,I need a holding bracket but ran out of time,today


Friday, 4 July 2014

Rotating tube clamp

 Boss had to be turned then welded to tube.Tightly sleeves over the landrover UJ and welded.I also drilled a hole in bottom of UJ to let the water out ,any trapped water in the winter can do some serious damage when frozen.

After Welding 






Studs welded to take up slack on  rotating pole.Inside the tube is 68mm,pipe will be 65mm ,so a little play .
 
    Bottom is drilled to put a drive dowel through the pole.Bit of cold galv and i recon the top is done .

What's left to do know is mount the rotary encoder on the base of output shaft ...and i'm good to go !!!

Saturday, 28 June 2014

Rotor controller interface

Rotor controller and pc interface ,running K3NG software and M0UPU shield for the arduino.Easy to put together just a plug in affair .Longest job was cutting the hole for the lcd display .This is just the interface for the pc the relays and 24v supply will be at base of tower ...well thats the idea for the moment !!

Rotor output shaft



Here's the output shaft for the rotator 40mm round bar turned down to 25mm then a plate welded on ,faced off then recessed for the universal joint (EX Landrover of course)



Will it fit .....oh yes





Boss to fit on top of UJ and carry antenna pole